Pressure Cleaning and Hot Water Pressure Washing

Pressure cleaning is one of the most effective tools for restoring hard surfaces — removing built-up dirt, grime, mould, oil staining, and biological growth that ordinary cleaning can’t shift. But it’s also one of the most commonly misused. The wrong pressure, temperature, or technique on a masonry surface can cause scarring, cracking, and structural damage that is expensive to repair.

Our technicians are trained specialists who assess every job before work begins, carefully matching pressure and temperature to the surface being treated.

Not all pressure cleaning is the same, and not all stains respond to cold water alone.

Cold water pressure washing uses high-pressure water to physically remove surface dirt, loose grime, and general soiling. It’s effective for routine cleaning of robust surfaces where the soiling is on the surface rather than embedded within it.

Hot water pressure washing adds heat to the equation — and heat changes everything. Hot water dramatically improves the breakdown of tough, bonded contaminants that cold water can’t effectively shift on its own. Our surface restoration vehicles are equipped with onboard boiler units that heat water to above 90°C, delivering superior results on the most demanding cleaning challenges.

Hot water is particularly effective for:

• Oil, grease, and fuel stains on concrete and asphalt
• Chewing gum removal
• Ingrained grime on high-traffic surfaces
• Mould and algae — killed at the source rather than just displaced
• Food court and bin enclosure cleaning
• Workshop and factory floor cleaning
• Any surface where cold water pressure washing has been tried and fallen short

Our surface restoration vehicles are custom-built and fully self-contained — arriving on site with everything needed to complete the job without relying on your facilities.

of onboard water · 3,000 psi pressure pumps · Onboard boiler units to above 90°C · Wastewater recovery systems · Full OH&S and traffic management equipment

Our self-sufficiency means we can operate anywhere, complete jobs faster, and save up to 45% of billable time compared to operators using undersized equipment — which directly reduces your cost.

Pressure cleaning is an unregulated service — anyone can buy equipment and offer it commercially. This means the quality and safety of service varies enormously, and we regularly attend sites to repair damage caused by operators using incorrect pressure, incorrect technique, or inadequate equipment.

Masonry surfaces — concrete, brick, render — are more susceptible to damage than they appear. Excessive water pressure erodes the surface, opens up pores, damages mortar joints, and can introduce moisture problems that cause long-term structural issues. The repair bill in these situations far exceeds the cost of using a qualified specialist from the start.

• Driveways and paving
• Car parks
• Sports courts
• Artificial grass
• Concrete and rendered walls
• Brickwork and stone
• Retaining walls
• Timber fencing and decking
• Tiles and cladding
• Factory floors and skylights
• Shade sails

Where standard pressure washing needs support, we can apply specialist cleaning formulations to assist in breaking down stubborn stains before pressure washing — ensuring thorough removal without abrasion or environmental harm.